Step 4. Install The Terminal Block - National Instruments PXIe-4353 Installation Manual

Hide thumbs Also See for PXIe-4353:
Table of Contents

Advertisement

For information about CJC and accuracy considerations refer to the
section.
Note
For information about sensors, go to

Step 4. Install the Terminal Block

Caution
Do not supply hazardous voltages (>30 V
without the terminal block being connected to the NI PXIe-4353.
Note
The chassis can be powered on or off when installing the terminal block.
Refer to Figure 5 to install the terminal block on the module while completing the following steps:
1.
Move the TB-4353 into position in front of the NI PXIe-4353 and engage the alignment feature
with the guide on the associated module.
1
PXIe Controller
2
PXIe Chassis
2.
Attach the TB-4353 to the NI PXIe-4353 module by pushing the terminal block straight into the
module. A spring mechanism will lock in the bottom of the terminal block.
3.
Tighten the mounting screw at the top of the TB-4353 to a maximum torque of 0.55 N·m
(4.9 lb · in.) to attach it to the NI PXIe-4353 module.
© National Instruments Corporation
1
3
5
6
4
3
Mounting Screw
4
TB-4353 Terminal Block
Figure 5. Installing the TB-4353 on the NI PXIe-4353 Module
Cold-Junction Compensation
.
ni.com/sensors
/42.4 V
/60 VDC) to the terminal block
rms
pk
2
5
6
7
NI PXIe-4353 and TB-4353 Terminal Block Installation Guide
NI PXIe-4353 Module
Alignment Feature

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tb-4353

Table of Contents