Summary of Contents for National Instruments CB-37F-HVD
Page 1
Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment SERVICE CENTER REPAIRS WE BUY USED EQUIPMENT • FAST SHIPPING AND DELIVERY Experienced engineers and technicians on staff Sell your excess, underutilized, and idle used equipment at our full-service, in-house repair center We also offer credit for buy-backs and trade-ins •...
Page 2
This guide describes how to install and use the National Instruments CB-37F-HVD 37-pin D-SUB high-voltage (150 V) DIN rail terminal block. The CB-37F-HVD has screw terminals for connecting up to 37 I/O signals. Use 12–30 AWG wire to connect to the CB-37F-HVD screw terminals.
UL listed industrial enclosure , electrical cabinet, or rack-mount cabinet National Instruments sells two UL listed industrial enclosures: FP-ENC1 industrial enclosure with polycarbonate window (part number 777596-01) and NI FP-ENC1 industrial enclosure with solid metal door (part number 777596-02). NI CB-37F-HVD Installation Guide ni.com...
1/8 in. flathead screwdriver – Wire insulation stripper Connecting the Signals To connect signals to the CB-37F-HVD terminal block, refer to Figure 2 while completing the following steps. Note Refer to the Read Me First: Safety and Radio-Frequency Interference document before removing equipment covers or connecting or disconnecting any signal wires.
Page 5
Note To replace the zip ties, remove one of the end pieces from the CB-37F-HVD. Slide the PCB out and guide the zip tie through the holes on the PCB. Replace the PCB, end piece, and screws.
Page 7
Storage temperature ........–20 to 70 °C Humidity ..........10 to 90% RH, noncondensing Maximum altitude........2,000 meters Pollution Degree (indoor use only) ..2 Safety The CB-37F-HVD terminal block is UL recognized and meets the requirements of the following standards for industrial control: • EN 50178 •...
Page 8
Instruments trademarks. Other product and company names mentioned herein are trademarks or trade names of their respective companies. For patents covering National Instruments products, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your CD, or ni.com/patents.
Page 9
Artisan Technology Group is your source for quality new and certified-used/pre-owned equipment SERVICE CENTER REPAIRS WE BUY USED EQUIPMENT • FAST SHIPPING AND DELIVERY Experienced engineers and technicians on staff Sell your excess, underutilized, and idle used equipment at our full-service, in-house repair center We also offer credit for buy-backs and trade-ins •...