Performing Basic Configurations At The Cli; Performing Basic Configurations In The Web Interface - H3C SecPath L1000-A Installation Manual

Performing basic configurations at the CLI

Step
1. Enter system view.
2. Set the system name.
3. Enable the Telnet server.
4. Enter Ethernet interface
view.
5. Assign an IP address to
the interface.
6. Configure dynamic NAT.
7. Add the interface to a
security zone.
8. Return to the upper-level
view.
9. Save the running
configuration.
10. Display the running
configuration.

Performing basic configurations in the Web interface

Configuring the system name for the L1000-A
1. Log in to the Web interface, and select System > Device Management > Device Basic Info from
the navigation tree.
Figure 27 Configuring the system name
Command
system-view
sysname sysname
telnet server enable
interface interface-type
interface-number
ip address ip-address { mask-length |
mask } [ sub ]
•
To create a NAT address group:
nat address-group group-number
start-address end-address [ level
level ]
•
To associate the ACL to the address
group:
nat outbound acl-number
[ address-group group-number
[ vpn-instance vpn-instance-name ]
[ no-pat | port-preserved ] ] [ track
vrrp virtual-router-id ]
zone name zone-name [ id zone-id ]
import interface interface-type
interface-number [ vlan vlan-list ]
quit
save [ safely ]
display current-configuration
29
Remarks
N/A
By default, the system name is
H3C.
By default, the Telnet server is
disabled.
N/A
By default, GigabitEthernet 0/0
has an IP address (192.168.0.1)
and the other interfaces have no IP
addresses.
N/A
Five security zones are predefined
in the system: Management, Local,
Trust, DMZ, and Untrust.
By default, GigabitEthernet 0/0
belongs to the management zone,
and other interfaces do not belong
to any zone.
N/A
N/A
N/A