Advertisement
ALL VEHICLES
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Open the
ashtray/cupholder assembly, depress the retaining clips on each side and remove the
assembly. Remove (2) Phillips screws from each side of the ashtray/cupholder assembly.
Remove (4) plastic rivets from the lower pocket and slide the pocket back. (NOTE: It is NOT
necessary to remove the pocket. Unclip the dash trim bezel and remove. Remove (4) Phillips
screws securing the factory head unit and disconnect the wiring.
2
Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down.
Slide the aftermarket head unit into the DIN cage until secure.
METRA ACCESSORIES
3
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the
dash.
Metra recommends using the
proper mating adaptor and making
connections as shown.
(Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
5
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) Phillips screws previously removed in step #1.
4
"A"
Locate the (4) mounting positions in the sub-dash
("A").
STEREO DASH KITS
Advertisement
