Advertisement
Quick Links
1.
INTRODUCTION
This Instruction Sheet describes the operation method of DYNAMIC CONNECTOR D5900 series.
Please refer to product standard 108-140022 for a detailed product performance of the connector.
2.
COMPOSITION
DYNAMIC CONNECTOR D5900 is composed of the Receptacle assembly and the Header Connector.
The circuit number is marked to the Receptacle assembly for correct installation.
3.
RECEPTACLE ASSEMBLY
3.1.
Receptacle assembly with spring opener (2260828-1)
3.1.1 Insert the hook head of spring opener (2260828-1) into a square hole on the wire insertion side
of the receptacle assembly.
3.1.2 Push the lever of the spring opener (2260828-1) with thumb at illustrated direction in Fig. 1 until
the rib on the opener enters the hole firmly.
*Operate the spring opener with receptacle assembly unmating with header connector, or the
header connector and PCB would be damaged.
3.1.1
© 2020 TE Connectivity family of companies
All Rights Reserved
| Indicates Change
*Trademark. TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
Instruction sheet
DYNAMIC CONNECTOR D5900 SERIES
Fig. 1
This controlled document is subject to change.
For latest revision and Regional Customer Service, visit our website at www.te.com
PRODUCT INFORMATION 1-800-522-6752
3.1.2
408-78067
1 MAY 2020 Rev A
1 of 4
Advertisement
Related Manuals for TE Connectivity DYNAMIC 5000 Series
Summary of Contents for TE Connectivity DYNAMIC 5000 Series
- Page 1 For latest revision and Regional Customer Service, visit our website at www.te.com | Indicates Change PRODUCT INFORMATION 1-800-522-6752 *Trademark. TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
- Page 2 408-78067 3.2. Wire Strip 3.2.1 Applicable wire size: AWG #8~#16(1.3~8.4mm2), Strip length: 13.7±0.5mm. *Strip length could be confirmed by comparing with strip gauge on 2 sides of receptacle assembly as Fig.2 shows. 3.2.2 In case of any undesirable twist, bending or loosening of conductors after stripping, fix the shape of the wires and confirm length with strip gauge before using.
- Page 3 408-78067 HEADER CONNECTOR The header connector is PCB installable connector with metal contact assembled. Horizontal type shown in Fig.4 is available. Recommended PCB thickness is 1.6mm~2.4mm±0.1. Before soldering procedure, push the header connector straightly until the retention legs are fixed to the holes on PCB and confirm no gap between connector and PCB.
- Page 4 408-78067 APPLICABLE WIRE Wires in Table.1 are available for D5900 series connector. SQ(AWG) Insulation diameter 1.3(#16) 2.15(#14) 8mm Max. 3.3(#12) 5.3(#10) 8.4(#8) Table. 1 OTHERS Wrap the wires as close as possible to the connector side (as shown in Fig.6). Recommended wrapping position in vibration environment is 10 cm max.