Tilt Ice* Dispenser; Adjusting Meat Pan Temperature; Removing The Meat Pan - Whirlpool ET22MT Use & Care Manual

Tilt Ice * Dispenser.. .
Adjusting meat pan temperature.. .
There are a few things you'll want to know about
the Ice btn and the automatic ice maker that fills it.
l
Bin is inside small door
on freezer doof
l
To open Tilt-Ice'
I
DisDenser Door, lift
up'on handle, tilt
door down.
l
Reach in, pull bin out
part way or remove it
I
from freezer.
l
If you remove bin,
STOP ice maker. Open
freezer door and push
lever to OFF. Push
it back ON when you
replace bin.
ON /OFF lever is
under
front
panel
l
You ~111 hear water filling the mold and ice cubes
falling into the bin. These are normal sounds.
l
The Ice maker WIII stop automatically when the bin
is full. It will start again when you remove ice.
l
Shake bin occasionally to keep cubes separated.
Tips,
l
New plumbing connectlons can give the first
cubes an odd taste or color. Just throw these
away. The Ice maker will refill the bin
l
Cubes stored too long may develop an off-
flavor...like stale water. Throw them away.
l
Cubes stored for more than a few weeks will
become smaller because moving air in the
freezer is so cold that it starts a slow evapo-
ratton If you use Ice often, you may never
notice shrinkage.
Cold air flows into the meat pan container through
an opening in the back of the refrigerator. This helps
keep the meat pan colder than the rest of the
refrigerator
Set the control to let more or less cold air through
Removing the meat pan.. .
The meat pan, shelf and container can be re-
moved for cleaning. When it is
reploced, it must
o/ways be /n the some position
1, Slide meat pan out.
2. Tilt shelf up ot front
3 Pull straight out.
7. Turn the
COLD to avoid
the refrigerator
section while the '
meat pan
IS
removed.
To replace (The meat pan container must
be replaced in the same position):
1 Position container so that opening fits overcoldair
Inlet. Guide rear hooks into slots
IP
shelf supports
Ttlt up front of container until hooks drop into slot.
Lower container to level posItIon.
2. Replace shelf over container.
3 Slide meat pan back Into container
4. Reset meat pan temperature control to desired
setting.
6
Tmk