Accessing Ice Maker And Dispenser Components - Whirlpool KRMF606ESS Service Manual

Accessing Ice Maker and Dispenser Components

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Ice Box Assembly
1. Complete the steps
1-11
Components instructions .
2. Disconnect electrical connections to ice box assembly.
3. Disconnect ice maker fill tube from water valve.
4. Locate the two 1/4" (6.4 mm) screws attaching the ice box
assembly and remove using 1/4" (6.4 mm) nut driver while
supporting ice maker.
from Refrigerator Compartment
5. Drop down the front of the ice maker assembly and slide out
to disengage the two tabs from the slots in the top of the
cabinet.
Ice Maker Fill-Tube
6. Remove foil fill tube heater from the ice maker fill-tube
on the ice box. Remove all wires from channel on ice box
assembly.
NOTE: Some models have a ice box fascia with fascia heater
wired through the foil fill tube heater, you may need to
remove the fascia heater wires and grommet from the ice box
cover.
A
7. Use a straight blade screw driver to remove five, 1/4"
(6.4 mm) screws securing the ice box cover to the ice box
assembly.
8. Remove ice box cover while guiding ice maker harness
through slot in ice box cover. Note lip for reassembly.
A
Multi-Door Freestanding Refrigerator
COMPONENT ACCESS
B
A. Grommet
B. Channel
A. Slot
n
4-19