Table of Contents
Advertisement
Removing the base grille...
-
-
To remove
the grille:
r
METAL CLIPS
-I
SUPPORT TABS
1. Open the door.
2. Pull grille outwards
as shown.
3. Do not remove
Tech sheet
fastened
behind
grille.
Ice compartment
door.. .
To replace
the grille:
1. Line up grille support
tabs with metal clips.
2. Push firmly to snap into place.
3. Close the door
Pull the Ice compartment
door panel
out from the
bottom and slide it to the rear
Ice cube trays...
(Model
ETZORK only)
If cubes are not used, they may shrink The mov-
rng cold air starts a slow evaporation.
The longer
cubes are stored, the smaller they get.
Automatic ice maker...
If you have Model
ET20RM with the automatic
ice maker accessory,
or if you have Model
ET20RK
and plan to add one later (Part No. ECKMF-831,
there are a few things you will want to know:
LOWER
SIGNAL
ARM TO
START IT
l
The ON/OFF lever is a wire signal
arm
Down...for
making
ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
To remove
ice:
1. Hold tray at both ends.
2. Slightly twist.
l
The dial
or lever on the side of the ice maker
changes
the size of the cubes.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain
increased
storage
CapaCitY
l
It is normal
for ice crescents
to be attached
by a
corner. They will break
apart
easily.
l
You will hear water
running
when
ice maker
is
working.
You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The ice maker
will not operate
until the freezer
IS cold
enough
to make
ice. This can
take
overnight.
l
Because
of new plumbing
connections,
the first
ice may be discolored
or off-flavored.
Discard
the first few batches
of ice.
l
If ice is not being
made
fast enough
and more
ice is needed,
turn the Refrigerator
Control
to-
ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control
toward
A
Advertisement
Table of Contents
