Related Manuals for Ingersoll-Rand 6W Series
Summary of Contents for Ingersoll-Rand 6W Series
- Page 1 45612751 Edition 1 August 2008 Air Angle Wrench 6W Series Maintenance Information Save These Instructions...
- Page 2 WARNING Always wear eye protection when operating or performing maintenance on this tool. Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any accessory on this tool or before performing any maintenance on this tool. Note: When reading the instructions, refer to exploded diagrams in parts Information Manuals when applicable (see under Related Documentation for form numbers).
- Page 3 3. Remove the tool from the vise and, while holding the tool 13. Remove the Throttle Plunger Seal (7) from the Throttle Plunger (6). horizontally, carefully unscrew the Gear Case by hand and pull it NOTICE away from the Motor Housing. 4.
- Page 4 Needle Bearing Inserting Tool for Planet Gears Assembly of the Motor and Throttle Gear Length – Bearing Length 1. If the Throttle Plunger Bushing (2) was removed, proceed as Shoulder Length = follows: a. Insert the Throttle Plunger Bushing into the Motor Housing (1) to a depth approximately one-half the length of the Bushing.
- Page 5 18. Lightly grasp the threaded hub of the Rotor in leather-covered or copper-covered vise jaws with the splined hub upward. NOTICE 19. Wipe each Vane (38) with a film of Ingersoll Rand No. 10 Oil and Always press on the stamped end of the Bearing and center the place a Vane in each slot in the Rotor.
- Page 6 4. For 7L3D6 Angle Head, insert the Spacer Assembly over the Minimum Dimension “A” splined end of the Bevel Pinion and into the Angle Housing until it is inch beyond the Spacer Retainer groove. Using a thin blade screwdriver, start the end of the Bearing Spacer Retainer opposite the tab end 0.718 18.25 into the groove in the Angle Housing.
-
Page 7: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Check the air pressure at the inlet. The pressure must not Low air pressure exceed 90 psig (6.2 bar/620 kPa). Plugged Inlet Bushing Screen or Air Strainer Clean the Screen in a clean, suitable, cleaning solution. If it Screen cannot be cleaned, replace it. - Page 8 www.irtools.com © 2008 Ingersoll Rand Company...
Need help?
Do you have a question about the 6W Series and is the answer not in the manual?
Questions and answers