Usage - CPS AC750 Owner's Manual

1. SAFETY INFORMATION

1.2 USAGE

1.2.1
1.2.2
1.2.3
1.2.4
1.2.5
1.2.6
1.2.7
1.2.8
1.2.9
1.2.10
1.2.11
1.2.12
1.2.13
1.2.14
1.800.561.8187
AC750RevA_Manual_091216.indd 5
DO NOT measure voltage greater than 750 V AC, 1000 V DC.
DO NOT measure resistor, capacitor, diode and circuit while
connected to power.
DO NOT measure capacitance before capacitor is discharged
completely.
DO NOT use meter in explosive gas, vapor or dusty environments.
DO NOT store or use meter in direct sunlight, high ambient
temperature or high humidity.
During test of currents, resistors, capacitors, diodes and circuit
connections, DO NOT connect meter to a voltage source.
DO NOT use unless meter bottom case and battery cover are
completely fastened .
During use, select the right function and measuring range.
During measurement, DO NOT exceed the indicated value for
each range.
When measuring a circuit with the meter connected, DO NOT
contact with probe tip (metal part).
During measurement, if voltage to be measured is more than
60 V DC or 30 V AC (RMS), always keep fingers behind finger
protection device
In the manual measuring range mode, when measuring an
unknown value, select the highest measuring range first.
Before rotating Selector Switch to change measuring function,
remove probe from circuit to be measured.
If you find any abnormal phenomena or failure of meter, stop
using immediately.
www.
information@itm.com
.com
5
2/14/2018 11:41:56 AM