CPS AC750 Owner's Manual page 23

4. OPERATING GUIDANCE
4. Connect probe with signal or both ends of load in parallel for
measurement.
5. VRead on LCD.
6. Pressing Hz/% again enters duty ratio measuring state.
Note:
1. Frequency measurement range is 10Hz~1kHz When the frequency
to be tested is less than 10Hz,the LCD will show 00.0 Measuring
frequency higher than 10kHz is possible, but accuracy is not
guaranteed.
2. Duty ratio measuring range is 10 ~ 95%.
3.
C) In HZ/DUTY Measurement Mode:
WARNING
PAY SPECIAL ATTENTION TO AVOID SHOCK WHEN MEASURING
HIGH VOLTAGE. DO NOT INPUT VOLTAGE MORE THAN AC 250V
RMS.
1. Insert black probe to COM jack, insert red probe to INPUT jack.
2. Set Selector Switch to position HZ.
3. Connect probe with signal or both ends of load in parallel for
measurement.
4. Read LCD.
5. Press Hz/% again to enter duty ratio measuring state.
Note:
1. Frequency measurement range is 10Hz~1kHz When frequency
to be tested is more than 10Hz, LCD will show 00.0. Measuring
frequency higher than 10 kHz is possible, but accuracy is not
guaranteed.
1.800.561.8187
AC750RevA_Manual_091216.indd 23
means maximum input voltage is 750V AC (RMS).
www.
information@itm.com
.com
23
2/14/2018 11:41:58 AM