CPS AC750 Owner's Manual page 12

3. SPECIFICATIONS
3.2.1 TRUE RMS ZERO INPUT CHARACTERISTIC
3.2.1.1 For measuring non-sinusoidal wave signals, use true RMS
3.2.1.2 This true RMS meter can accurately measure non-sinusoi-
3.2.1.3 True RMS can be measured only when input signal reaches
• Maximum input current:
• Maximum input current:
12
1.800.561.8187
AC750RevA_Manual_091216.indd 12
measuring method, which has less error than traditional
average response measuring method.
dal wave signals, but in AC function mode, when there is
no signal to be measured (input terminal short circuit in AC
voltage mode), clamp meter may show a reading from 1 to
50. These deviating readings are normal. In the designated
measurement range, they will not affect the accuracy for
multimeter measuring AC.
a certain level. Therefore, the measuring range of AC
voltage and current should be specified at 2% ~100% of
full range.
3.2.2 AC CURRENT
Measuring range
60A
600A
1000A
www.
Resolution
0.01A
0.1A
±(2.5% reading + 8 digits)
1A
1000A AC
0~600A: 40~400Hz;
600A~1000A: 40~60Hz
.com
Accuracy
information@itm.com
2/14/2018 11:41:57 AM