Table of Contents
Advertisement
OLIMEX© 2016
•
In the "New-line" box change the value for the "Transmit" field to "CR+LF". It should look like this:
•
Now the terminal is set properly. We can send AT commands to the board now. It is important to
notice that the AT commands should be capitalized!
•
For example, type "AT" and press "Enter". Then type "AT+GMR" and press "Enter". You should
receive the following response:
For the full AT command set – it is always the best idea to refer to the official documentation released by
Espressif Systems!
Page 15 of 17
Upgrading ESP8266
Advertisement
Table of Contents
Need help?
Do you have a question about the ESP8266 Series and is the answer not in the manual?