Remote Operator - Hitachi J300 Series Instruction Manual

Display when the autotuning terminates
[Display in the normal state]
When the autotuning terminates normally, the following is displayed. When one of the keys is
pressed, the original screen is displayed.
.Digital operator
Normal terminatjon display
.Remote operator
.New remot€ operator
fT;-
[';r.-l
Normal i,erminalion display
lDisplay in the failure state]
. lf the autotuning is executed when the motor is not connected to the inverter, the following is
displayed and the measurement is stopped. As a motor constant when the measurement fails, the
last value is set. When one of the keys is pressed, the original screen is displayed. When execut-
ing the measurement once again, change the autotuning measurement setting to "Start" and enter
the lun command in the same way.
.Digital operator
OK I Function
3 O R FR
Abnormal terminalion display
NG Function
3 OR
FR
fT
l;l-
l*-"r*l
Abnormal tcrmination display
When running the inverter using the autotuning data after the autotuning measurement lerminales,
make settings by the method indicated on the next page.
.Remote operator
.New remote opelator
A4