Hitachi J300 Series Instruction Manual page 52

Adjusl &e analog meter connectcd lo the trequency monitor
lerminal. (Initial selting of lhe [FM ] terminal: Analog frequency moniror)
W}l€n opcration starts. t/T output between FM and CMI terminals is
proportional to dr output daia. Adjusr rhe mcler so that ir indicates
the ma).imum poinl when the output r\ al rhe maxrmum.
tlDD
I
l 1
- { t i r i n g
' r.luge
{ r r i n g
-tt
r l
F-L'i
U]f
&
NOTE l: This function is valid only whcn the analog moniror is used.
(Frcqency monjtor, current moniror, torque moniror)
NOTE 2: The adjust€d value when lhe input t€rminal STN (initialization) is used is
the initial value.
Conrenls and display
. s€t the molorreceiving
vottag". wh-,h"[SiEcltey is prcss€d once, rhe current ser va]ue
of6€ rnotorrccciving voltage is displayed-
. Set $e receiving voiDge
from the dala on $e lefr.
4oo v crass lJm FIEEI m.-3 BqA Fm
Sclccl the item ofeach exrension function. After sefting, the display is retumed io the code
disolay.
Oiiti. a",u i' .nung"a. u" \ure ro pre\\ rhe
ffi
t.r r,.ro,. ir.
l v a
* v -
Whcn fte data is chang€d.
the display blinks.
(Ser value srorage wajt siatc)
m-Hsl
When lhc IFUNCI key is pressed, rhe display slops
blin]l(ing and the data is stored.
l ^ l l v l
l*;E I
lv
littE
EUlq Initialvaluc E!!91
lFfIB -'-----------f-rTTPl
-ff
- . t | _
a l v
* -
wl1en adjuning the malog netei funhemor€, reFar thc @e openron_
Maximum level of analog meter
Fequency monibn (A63 maxinln nequency sening)
cuftnl monllor (200% of invener ded cuden0
Torquc monitor (2m% ot nrd rorqnc)
7-13