Hitachi J300 Series Instruction Manual page 37

Operating with digital operator:
Procedure
( I ) Tum on ELB to supply power to the invener. Make sure that ttre @ Lro on tle dlgitat
operator tums ON.
(2) hess the l_rffi key once to display lc/T-c|.
t3t ftess S of the digital operator four times to di"plal [f].
(4) Press the ffi key and then press the
p key to set l-lDDl . er"r. tn" | ,tLE"l
key to establish the data.
(5) Press the E key four times to display
FI-?r.
(6) Press E of the digital operaton five
times to dispaly IFT-Z.
(7) Press the @
tey ana then ttre E
key so as to increase to frequency or the
E key so as to decreaie the frequency.
(When the LlU or LVI key i\ pressed
conlinuously.
the frequency is changed
continuously.)
-, i-'rlr l, . r------
wnen rne I F-Nc I Key rs presseo. l!l__gl
is displayed.
(8) Check dre outpul frequemcy and rolalion
drrectron. when the a
or El Key rs
pressed to display [f]
and then the
ffi
tey is pressed.lhe rolalron direc-
tion can be checked. lFI_l indicates
lorward rotalron and lr i
I rndrcales
reverse rolalion. When fte rolalior
, r n t
drreclron rs cnecKeo. pres5 lne | .jil I
key. When the rotation direction cannot
be found, operate the equipment at a low
frequency to check the rotation direction.
(9) Preisl rhe I Fri I f"y. The dequipment
stafts running.
F---.-*-;-ii
{ I0) Press the lsio'.qc;-l kei. The equipment
decelerates and stops.
Runnign from external command:
(4) Press the ffi key and then press the
E key ro set flDl . r."., rn" f,ffil
key to establish the data.
(5) Press the @ key four times to display
|a-e.
(6) Shofi the terminals FW and P24 (CMl*)
of the control teminal block.
(7) Apply a voltage between the terminals O
and L to start running.
(8) Open tie terminals FW and P24 (CM I *)
of the control terminal block to stop
deceleration.
Symbols are indicated for Sink
Refer to page 5-5.