Advertisement
Item Description
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Torx Driver
Philps Screwdriver
Description #3
Description #4
Description #5
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. System Board Battery (1G/10G I/O Board)
a. Remove 2 screws on rear side of Juno Chassis with T-10 Driver.
b. Slide Hood and remove 2 Black Screw with T15 Driver to detach PCIe/PXIe Baseboard Kit.
c. Remove 2 HDD Cage Screw with T10 Driver than you could
2. Capacitance
Capacitance which is inserted by operator
a. let tin touch the two pin of the capacitance
b. second, soldering tin the points with Soldering Station which set the temperature to 330
c. 10oC for L/F model , if non-L/F model, set the temperature to 300
d. 10oC, remove capacitance from PCB after tin completely melting, and then put it into Recycled Box(Remark:if
capacitance which is disassembled is GND ,Set the Soldering Station(Gao Zhou)temperature to 300 � 10oC,
remove capacitance from PCB after tin completely melting,
e. Put it into Recycled Box
(Remark: if capacitance which is disassembled is GND, Set the Soldering Station (Gao Zhou)
3. Capacitors in 800W/500W PSU
a. 2.5 cm Pull down the lid to release the power supply from Chassis
b. Removing 2 screw on the Bottom Side with T15 Driver
c. Removing 1 screw on the Right Side with Philips Driver
d. Removing 4 screw on the Fan Module
e. Open its cover and locate the capacitors and pry from the PCB with a flat head screw driver or long nose plier and
dispose of properly.
MF877-00
Template Revision A
Notes
No
No
HPE instructions for this template are available at
MF877-01
Quantity
of items
included
in product
0
0
Tool Size (if
applicable)
T-10/15
Page
2
Advertisement
