Installing Lock - Samsung SHP-A30 User Manual

Installing lock

|
Outside
A
E
Caution when Installing Product
 Before installing an IoT door lock, check your wireless environment. Depending on the indoor wireless
environment, an IoT door lock may not be installed or its service may not be supported. To check your
wireless environment, you need a smartphone and a wireless access point (AP) in your house.
 Install the door lock while the door is open. Even after completing the installation, do not close the door
until you check if the door lock operating properly.
 While installing this product, do not let the door lock fall to the ground. If this product falls or is dropped
during installation, you may be injured or the product may be damaged.
 When installing this product, check to see if the dead bolt fits in the door. The dead bolt should be in the
lock position until the batteries are inserted.
1. Installing the Dead Bolt(E)
E
G1
* If there is round strike hole, change the faceplate, and
C
F3
F2
1. Before installation
1) Check the faceplate type of your door.
2) Make sure the deabolt directon as shown before
inserting it into a door side.
2. Insert the deadbolt from the side of the door.
3. Fix the deadbolt using two FH+T4X19 screws.
insert the deadbolt following right side drawing.
Inside
B
F4
F4
9
SHP-A30
Samsung SDS
Digital Door Lock
G
I
J
D