Samsung SHP-A30 User Manual page 13

Symbols
Place the finger on the
U FP
fingerprint sensor
Enter the User Number. Can be
U No
set from 1 to 50.
Definitions
|
2-Step Authentication Mode :
the door, ensuring more security. To set this mode, one or more fingerprints need to be registered.
Away mode
: When you go out, the lock generates an alarm sound when an attempt is made to
forcefully open the door from the inside. In the Away mode, if someone tries to open the door from
the inside, the emergency alert lamp on the outside blinks and the "beep- beep- beep-" sound is
generated for 5 minutes.
Locking Mode (Auto/Manual) :
automatically when it is closed. The factory default is 'Manual mode'.
- Auto : When the door is unlocked, it is automatically locked after a preset time (10/30/60/120 sec-
onds). However, it does not function if the batteries are completely discharged.
- Manual : The door does not lock automatically when it is unlocked, If you touch the [Touchscreen]
or press the [OPEN/CLOSE] button on the Interior Unit, The door will be locked.
Lockout Mode (Protect Mode) :
tered PIN Codes/Fingerprints occur, the lock disables the keypad for 3 minutes for security reasons.
The lock is re-activated again automatically after 3 minutes and may still be operated using the home
control or security system.
Low Battery Indicator :
the standard voltage, and activates the Low Battery Alarm ("Please change the batteries") to indi-
cate that the batteries need to be replaced. In case of the low battery, the low-battery LED flickers
when using doorlock.
Master PIN Code :
You can enter only one Master PIN (4-12 digits) Code. You can register the
User PIN Codes/Fingerprints after authenticating with the Master PIN (4-12 digits) Code. You can
open the door with the Master PIN Code, and the factory default is '1234'.
OPEN/CLOSE Button :
door from inside in the Manual locking mode.)
Privacy Mode :
Press and hold the [OPEN/CLOSE] button for more than three seconds, if three
beeps deactivate the keypad. As it is set from the inside, provides a secure lock for the convenience
of the occupant(s). Privacy mode disables remote control capabilities.
Randomizer function :
prevent the intruder to see the fingerprint marks left on the touchscreen. You can also disable this
feature, but is enabled by default.
Description
Both PIN Code and fingerprint need to be authenticated to open
You can enable or disable the function for locking the door
When more than 5 failed authentication attempts with unregis-
Refers to the state when the operating voltage of the lock is lower than
A one-touch button to open the locked door. (It is also used to lock the
Press two-digit random numbers before the user PIN code in order to
13
Samsung SDS
Digital Door Lock
Symbols
Repeat the process inside
the rectangle.
Press the [OPEN/CLOSE]
OPEN / CLOSE
button.
SHP-A30
Description