Samsung SHP-DH525 User Manual

SHP-DH525
Convenient Opening
User friendly access with cards and password
Welcome Function
When a user gets close to the door lock,
the authorization standby mode will
automatically activate.
Silent-Mode Function
When going in or out, the sound of the
key entering and door opening will be
suspended.
Security Assurance Function
When someone is inside the house,
authorization for entry from the outside
will be prohibited.
Built-in Fire Detection
Generates alarm in case of a fire
Security Function
Prevents intrusion from the outside
Smartphone Interworking function
Conveniently open the door through the Bluetooth
function of a smart phone
www.samsungsds-nss.com/en
Opening the Door from Outside with a Password
When purchased, the product is set to Multi-leveled Security Code Entry Mode
initially. Please refer to "Multi-leveled Security Code Entry Mode setting" for Com-
mon Mode setting.
※ Silent Mode
Before entering the password, press the [] button and enter the password, then both
the sound of the key entering and the door opening will be suspended. It is a useful
function if you do not want to disturb neighbors when you go in and out at night.
1. Multi-leveled Security Code Entry Mode
Touching [Number When two arbitrary but- When the numbers on the number
Pad] will light up tons are lighted, press pad are lighted, enter the password
the number pad. the buttons in order. and press the [] button.
- If the security mode is changed as 'common mode', second step will be skipped.
2. Common Mode
Success:
DING DONG DENG DONG
Fail:
DING DONG DING DONG
Touching [Number Enter the password when the
Pad] will light up number pad is lighted, and press the
the number pad. [] button.
● Password must be entered after the light is on, and if does not, touch
[Number Pad] and re-enter.
● To cancel, press [
] button and re-enter.
Note
● If the password is wrong 5 times, "peep" warning alarm will sound 20 times
and the system will shut-down for about 3 minutes. When malfunction
happens, "beep" will sound every 10 seconds, and stop mode will be
turned off automatically after 3 minutes with multiple 'beeps'.
Opening the Door from Outside with a Card or Key Tag
The door can be opened from outside using a card or key tag.
Place the registered card or key tag on the card reader.
BIOMETRICS BIOMETRICS BIOMETRICS
Placing the Card or Key Tag on the Card Reader
Success:
DING DONG DENG DONG
Fail:
DING DONG DING DONG

Safety Cautions

This section contains important information to ensure the user's safety
and prevent potential damage to property. Please, read this section
carefully and use the product accordingly.
Warning
• The user shall not install or repair the
product without authorization.
• Do not install the product in the place
where the gap between the door and the
frame is 5mm or more.
• Make sure that no unauthorized person
has the access to the password.
• Do not operate the product with wet
hands, and keep liquids such as water
or drinks away from the product, or the
product may malfunction or be damaged.
• Do not use the excessive force or sharp
objects to push the lockbuttons, as this
can damage the product.
• Make sure that the door is completely
closed when going outside. The
manufacturer does not assume the
responsibility for any harm caused by
engagement of the lock on an improperly
closed door.
Product Components
The product components used may vary depending on the installation
environment.
Outer Body
Key Tag ( 2 EA)
User Manual, Product Warranty
'AA' Batteries (LR 6 )
Emergency Key
GC68-02211B ED:01
Opening the Door from the Inside
Pulling down the Door Lock Handle
Rotate the door lock handle of the inner body
Success:
downward.
DING DONG DENG DONG
Fail:
DING DONG DING DONG
Closing the Door from the Inside
Automatic
Locking Setting
Manual
Locking Setting
● To check if the door is locked from the inside, press the security button briefly;
the red LED will flash if the door is locked and the blue LED will blink if the door
is unlocked.
Note
● For 5 seconds after the door is closed, the Bluetooth authentication mode is
not turned on even though you approach the door lock.
(Note that the Bluetooth mode is turned on when you touch the number pad.)
Initialization (Password, Bluetooth,Card, Key Tag)
All registered data (password, Bluetooth, card, key tag) are deleted. After initial-
ization, the password is set to '1234', and the registered card, key tag data are
erased. Please register a new password after initialization.
1. Pressing the [Register] Button
(from the inside)
Press and hold the [Register] button for
5 seconds.
Place the card or key tag on
the card reader.
The door will be opened after
1 second.
4
• Please do not hang on the product or pull it.
• Long-term exposure to direct sunlight
may cause a crack on its touch pad.
Avoid exposure to direct sunlight during
installation.
• During battery replacement, use a new one
instead of the existing battery.
• Be sure to correctly match the poles (+/-)
when installing the batteries. Install the
batteries with the correct poles (+/-).
• Do not use water, benzene or alcohol when
cleaning the product, as these fluids can
cause product malfunction.
• Replace the batteries within 1 week after
the battery replacement alarm sounds.
• Interference in wireless communication may
occur when this product is used.
• According to the wireless communication
environment, its battery may consume
much.
Mortise Strike
(SHS-AML320)
Or
Mortise Strike Strike
(SHS-AML220) box
Inner Body
Handle Shaft Spring
Handle Shaft, Installation Screws
Installation Manual
DING DONG DENG
The door is automatically locked 1 seconds after
the door is closed.
The door is locked when the [Close] button
is pressed.
2. Entering the Numbers for
Initialization (from the outside)
DING DONG

DING DING

Success: DING DONG DENG
DING DING
Fail: DING DONG DING
DING DING
DONG
When the number pad is lighted, enter
'4560852580' and then press the [] button.
Outer Body Parts
Number Pad
Touch Number Pad
Unlighted
Entry Complete/
Silent Mode
Switch Button
Battery
Replacement
Time Alert
External Power
Contact Part
Inner Body Parts
Battery Cover
Registration
Button
Outer Body
Handle
Mortise
Deadbolt
Latch bolt
Open-door
sensor
2
SHS-AML320
Password Change
The password can be 4~12 digits number. Only one password can be registered.
1. Pressing the [Register] Button 2. Entering the Current Password
(from the inside)
DING DONG
Open the battery cover of the inner Enter the current password ('1234' after
body and briefly press the [Register] initialization) when the number pad is
button. lighted, and press the [] button.
3. Entering a New Password 4. Checking New Password Operation
(from the outside)
DING DING DENG
Enter the new password (4 to 12 digits) To make sure the password has been
and press the [] button. properly registered, check the new
password and close the door.
● Manage your password with care so that unauthorized people will not
have access to it. Regularly changing your password can reduce the
risk of it being leaked.
Warning
Card and Key Tag Registration
Up to 20 cards, including the key tag, can be registered.
(Only ISO14443 A Type is available.)
1. Pressing the [Register] Button
(from the inside)
DING DONG
Open the battery cover of the inner body
and briefly press the [Register] button.
3. Placing the Card or Key Tag on the
Card Reader (from the outside)
DING DONG DENG
CARD
Place the card or key tag to be registered on
the card reader of the outer body. You will
know the card or key tag has been registered
when "DING DONG DENG" sounds.
● To register multiple cards or key tags, lightly place another card
or key tag to the card reader within 20 seconds after registering
5
the previous card or key tag.
Warning
Number Pad Lighted
Card Reader
Proximity Sensor
Number Pad
Away Security
Setup
Emergency Alert
Light
Double Lock Light
Reset Switch
Outer Body
Handle
Built-in Wireless
Module (Optional)
Sound Control Switch
Auto/Manual
Locking Switch
CLOSE Button
Manual Open and
close Lever
3
SHS-AML220
(from the outside)
DING DONG DENG,
DING DING
(from the outside)
DING DONG DENG
DONG
2. Entering the Password
(from the outside)
DING DONG DENG,
DING DING
Enter the password ('1234' after initial-
ization) when the number pad is lighted,
and press the [] button.
4. Confirming Card or Key Tag
Registration (from the outside)
CARD
Place the registered card or key tag
to the card reader on the outer body.
6