Table of Contents
Advertisement
Using Your Refrigerator
Continued
Condenser coils
, ,,
Metal, clips
defrost pan
Support tabs
Raise
slgnal
arm to
stop ice.
Lower
signal
arm to
start it.
Removing
the base grille
To remove
the grille:
1. Open the door.
2. Pull grille out as shown.
3. Do not remove
Tech Sheet fastened
behind grille.
To replace
the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the door.
See cleaning instructions for defrost pan and
condenser coils on page 10.
Ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove
ice:
1. Hold tray at both ends.
2. Twist slightly.
Optional
automatic
ice maker
If you have the automatic ice maker accessory, or
if you plan to add one later (Part No. ECKMF-90)
there are a few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down.. .for making ice automatically.
Up...to shut off the ice maker.
NOTE: Do not turn ice maker on until it is con-
nected to the water supply. Instructions for ice
maker water supply hook-up are attached to
the back of the refrigerator cabinet.
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
l
Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
first few batches of ice.
Advertisement
Table of Contents
