Awning Switch Installation; Awning Lights Switch Installation - Carefree FREESTYLE EVOLUTION Installation Manual

F E A
REESTYLE VOLUTION
A S
WNING WITCH
(Refer to the wiring diagram on page 11.)
1. At the switch location cut a 2.32" x 1.5" hole.
2. From the module, terminate the three (3) 20awg
wires (Brown, Yellow and Gray) with .187, 18-20
awg female terminals.
E /R
XTEND ETRACT
diagram.
3. From the module, terminate the Violet wire with a
.187, 18-20 awg female terminal. Attach to the
ON/OFF switch.
4. Run a minimum 14 awg wire to +12VDC. Terminate
the wire with .187, 14-16 awg female terminal and
connect to the second terminal of the ON/OFF switch.
NOTE: If the wire run is 30 feet or longer, use
12awg wire to prevent voltage drop.
appropriate wire terminals for the wire size.
5. Push the wires and switches into the hole then attach the switch frame using 4 #6 x 1/2" screws.
6. Snap the switch bezel over the switch frame.
A L
WNING IGHTS
NOTE: Installers may choose to furnish the control switch or may wire directly to a multiplexing control
center.
O N
2 . 9 "
O F F
#6 x 1/2" Screw (x2)
1 . 8 8 "
1. Determine the location of the switch.
2. At the switch location, cut a 1.13" x 1.5" hole.
3. Wire the switch as shown. Wire terminals at the switch are .187, 18-24 awg female disconnects.
4. Press the wires and switch into the mounting hole. Secure the switch using two (2) #6 x 1/2" screws.
5. Snap the switch bezel over the switch frame.
10
Installation Manual
WNING
I
NSTALLATION
Attach
switch as shown in the wiring
S I
WITCH NSTALLATION
1 . 1 3 "
1 . 5 "
to the
O N
O F F
A w n in
g C o n
O N
O F F
Use the
A w n in
g C o n
To +12VDC
Single Pole, Single Throw Switch
To Multiplexing
Controller
Multiplexing Control Connection
Carefree of Colorado
Optional
Covered Bezel
R E T R
A C T
E X T E N
D
tr o l
R E T R
A C T
E X T E
N D
tr o l #6 x 1/2" Screw (x4)
White/Violet
(20awg)
White/Violet
(20awg)
1"
2 . 3 2 "
1 . 5 "
BT001
BT004d
070036-001r1