Connect The Piping; Connecting The Piping To Indoor; Connecting The Piping To Outdoor - Panasonic CS-RZ25VKRW Service Manual

12.2.5

Connect the Piping

12.2.5.1

Connecting the Piping to Indoor

For connection joint of all models
Please make flare after inserting flare nut (locate at
joint portion of tube assembly) onto the copper pipe.
(In case of using long piping)
Connect the piping

Align the center of piping and sufficiently tighten
the flare nut with fingers.

Further tighten the flare nut with torque wrench in
specified torque as stated in the table.
Spanner or
Wrench
12.2.5.2

Connecting the Piping to Outdoor

Decide piping length and then cut by using pipe cutter.
Remove burrs from cut edge.
Make flare after inserting the flare nut (locate at valve)
onto the copper pipe.
Align center of piping to valve and then tighten with
torque wrench to the specified torque as stated in the
table.
Torque
wrench
65
Additional Precautions For R32 Models when
connecting by flaring at indoor side
Ensure to do re-flaring of pipes before connecting to units
to avoid leaking
Seal sufficiently the flare nut (both gas and liquid sides)
with neutral cure (Alkoxy type) & ammonia-free silicone
sealant and insulation material to avoid the gas leak
caused by freezing.
Apply neutral cure
(Alkoxy type) and
ammonia-free silicone
sealant along the
circumference
Neutral cure (Alkoxy type) & ammonia-free silicone
sealant is only to be applied after pressure testing and
cleaning up by following instructions of sealant, only to
the outside of the connection. The aim is to prevent
moisture from entering the connection joint and
possible occurrence of freezing. Curing sealant will
take some time. Make sure sealant will not peel off
when wrapping the insulation.
Do not overtighten, overtightening may cause gas leakage.
Piping size
6.35 mm (1/4")
9.52 mm (3/8")
12.7 mm (1/2")
15.88 mm (5/8")
19.05 mm (3/4")
Torque
[18 N•m (1.8 kgf•m)]
[42 N•m (4.3 kgf•m)]
[55 N•m (5.6 kgf•m)]
[65 N•m (6.6 kgf•m)]
[100 N•m (10.2 kgf•m)]