Whirlpool SF360BEE Use & Care Manual page 27

S
EALED SURFACE BURNERS AND COOKTOP
To clean the burners:
1.
Pull the burner cap straight up from the
burner base.
2.
Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a
mildly abrasive scrubbing pad or cleanser.
Do not clean the burner cap in a dishwasher
or self-cleaning oven.
3.
If the gas tube opening has become soiled or
clogged, use a cotton swab or a soft cloth to
clean the area.
4.
If the ports are clogged, clean them with a
R
EMOVING THE OVEN DOOR
For normal use of your range, you do not need to
remove the door. However, if you have to remove
the door follow the instructions in this section.
NOTE: If the door removal pins included in the
Anti-Tip Bracket Package are not available, nails
or screws may be used. Be careful that the length
of the nail or screw does not damage the oven
by chipping or scratching the porcelain surface.
straight pin. Do not
enlarge or distort the
port. Do not use a
wooden toothpick. If
the burner needs to be
adjusted, call a qualified
technician for service.
.
CONT
( )
5.
After cleaning the gas tube opening and ports,
Alignment
pin
6.
Turn on the burner to see if it will light. If the
burner does not light after you have cleaned it,
recheck cap alignment or contact an authorized
service technician. Do not service the sealed
burner yourself.
Insert door removal
pin here
Oven door
CARING FOR YOUR RANGE
replace the burner cap.
To replace the burner
cap, make sure the
alignment pins on the
cap are properly aligned
with the burner base.
Range
Hinge
hanger
continued on next page
27