Indicator Lights - Whirlpool SF360BEE Use & Care Manual

T
HE ELECTRONIC OVEN CONTROL

Indicator lights

(see below)
Auto clean pad
(p. 22)
Bake pad
(p. 12)
Display
•
When you first plug in the range, "PF" will appear
on the display until you press any command pad.
If "PF" again appears on the display, your electric-
ity was off for a while. You will need to reprogram
any temperature adjustments you may have
made. See the "Adjusting the oven temperature
control" section.
•
When you are using the oven, the display will
show preheat times and temperature settings.
•
When you are not cleaning or cooking with the
oven, the display will be blank.
•
When setting a function, if you do not press the
start/enter pad within 5 seconds, the Start?
indicator light will flash. If you do not press the
start/enter pad within 5 minutes, the function
will be canceled.
Indicator lights
An indicator light to the left of the display lights up
when you are in a setting. An indicator light also
lights up to tell you when the door is locked. An
indicator light on the display lights up when the
oven is on.
CLOSE DOOR ON
BAKE
BROIL
START ?
PREHEAT
CLEAN
DOOR LOCKED
CUSTOM AUTO
BAKE
BROIL CLEAN
Custom broil
pad
(p. 16)
SELF-CLEANING OVEN
START
OFF
TEMP
ENTER CANCEL
5 SEC
Temperature
pads
(pp. 12, 15, 17)
Using the control lock
The control lock lets you disable the control panel
command pads. The control lock comes in handy
when you want to prevent others from using the oven.
NOTES:
•
You can only use the control lock when the oven is
not in use or the control has not been set.
•
Set the control lock when cleaning the control
panel to prevent yourself from accidentally turning
on the oven.
•
You must reset the control lock if the power goes
out for more than 1 second.
To lock the control panel:
Press and hold the start/enter pad for 5 seconds.
You will hear a single tone and "Loc" will
appear on the temperature display for
START
5 seconds. "Loc" will then appear when-
ENTER ever a command pad is pressed.
5 SEC
To unlock the control panel:
Press and hold the start/enter pad for 5 seconds.
A single tone will sound and "Loc" will
disappear from the temperature display.
START
ENTER
5 SEC
USING YOUR RANGE
Electronic
display
Start /enter pad
(p. 12)
Of f/cancel pad
(p. 12)
11