INSTALLATION
AND SERVICE
INFORMATION
INSTALLATION
THE INSTALLATION,
ADJUSTMENT
AND SERVICE OF
THIS APPLIANCE
MUST
ONLY BE PERFORMED
BY
A QUALIFIED
INSTALLER
OR SERVICEMAN.
This is
to insure correct
adjustments
for safety and for proper
performance.
CLEARANCE-Observe
all instructions
for minimum
clearances
to any combustible
surfaces. These should
be in accordance
with information
on the nameplate
and with national
fire laws.
VENTING-Never
block vents (air openings)
on the
range. Vents provide
air which
is needed for proper
operation.
CARPETING--Range
should NOT be installed
direct-
ly over kitchen
carpeting
unless
an insulating
pad
or 'h-inch thick plywood
is placed between the range
and carpet.
TYPE OF GAS-There
are two major types of gas-
Natural
and LP (Bottled).
Ranges adjusted
for one
type of gas CANNOT
be used with the other type of
gas until
ADJUSTMENTS
ARE FIRST MADE BY A
QUALIFIED
SERVICEMAN.
LOCATION
OF NAMEPLATE
The model
and serial
numbers
for this appliance
are
found
on the nameplate.
These numbers
must be used
when requesting
service
from your dealer, serviceman
or from us. Please record these numbers
in the space
provided
on the inside front cover.
The nameplate
is located under the cooktop
on the left
side wall of the burner box or near the center rear of the
burner box. On built-in
ovens, the nameplate
is located
on the main front oven frame.
ELECTRICAL
CONNECTIONS
ON A
GAS APPLIANCE
ALWAYS
DISCONNECT
POWER TO RANGE BEFORE
SERVICING.
Ranges
equipped
with electrical
power
have a three-
prong grounding
plug. FOR PERSONAL
SAFETY THIS
RANGE
MUST
BE
PROPERLY
GROUNDED.
THE
THREE-PRONG
PLUG MUST BE PLUGGED
DIRECTLY
INTO
A PROPERLY
GROUNDED
THREE-PRONG-
TYPE WALL RECEPTACLE.
DO NOT REMOVE THE THIRD GROUNDING
PRONG
FROM THE POWER CORD PLUG.
DISCONNECTING
ELECTRICAL
POWER
ON A GAS APPLIANCE
There
are two ways to disconnect
electrical
power to
a gas appliance.
Either
unplug
the three-prong
plug
at the wall receptacle
or unplug
the range power dis-
connect
plug,
located
under
the cooktop
behind
the
right rear burner,
by pulling
up.
On built-in
ovens, the disconnect
plug is located
under
the bottom plate in the broiler compartment
on the right
side of the compartment.
PRESSURE
REGULATORS
Regulators
maintain
the pressure of the gas coming into
the range unless the pressure
in the line drops below
normal. By controlling
this pressure, thesizeand
appear-
ance of the burner
flame will remain constant.
If you
should
move to a new location
or change fuels, contact
your serviceman
to adjust the range or built-in
unit to the
new fuel.
IF A TWO-PRONG-TYPE
WALL RECEPTACLE
IS EN-
COUNTERED,
IT IS THE PERSONAL
RESPONSIBILITY
OF THE OWNER
TO HAVE IT REPLACED
WITH
A
PROPERLY
GROUNDED
THREE-PRONG-TYPE
WALL
RECEPTACLE.
THE
THREE-PRONG
GROUNDING
PLUG IS FOR YOUR PROTECTION
AGAINST
SHOCK
HAZARDS.
20
Need help?
Do you have a question about the SF335EEPW0 and is the answer not in the manual?
Questions and answers