Hitachi C 8FC Manual page 5

Disassembly
No.
of Section
6 Stopper Pin
7
Vise Ass'y
8
Guard
Section
Method of Disassembly
--- 5 ---
A. Following the proce-
dures described
above, perform
disassembly as far as
removal of the Arma-
ture Ass'y [74].
B. With the pliers, ex-
tract the Retaining
Ring (E-Type) [46]
from the Stopper Pin
[52], and take off the
Stopper Pin [52] and
the Spring [45].
A. Remove the M6 x 11
Knob Bolt [54], and
remove the Vise
Shaft [60] from the
Vise Ass'y [53].
B. Remove the M4 x 10
Machine Screw [59],
and take off the M10
x 66 Knob Bolt [55]
and the Vise Plate
[58].
A. As described in
Paragraph 1-(1)-A,
take off Guard (A)
[17].
B. Remove the two
M4 x 6 Flat Hd.
Screws (Brass) [19],
and remove Guard
(B) [20] by pulling it
forward.
Tools Required
Pliers
Phillips Hd.
(Plus) Screw-
driver
Phillips Hd.
(Plus) Screw-
driver