Hitachi C 8FC Manual page 9

* Confirmation of Saw Blade Lower Limit Positioning:
Prior to shipment, the lower limit position of
the Saw Blade is factory adjusted so that the
dimension from the bottom surface of the
Gear Case to the surface of the Turn Table is
between 62.3 mm and 63 mm, as illustrated
in Fig. A. The customer should be advised to
confirm that it is properly adjusted prior to
operating the machine. If the lower limit
dimension is not within the designated
amount, there may be cases when the lower
part of the workpiece on the fence side may
not be cleanly cut off.
If adjustment is necessary, turn the lower limit
adjusting M5 x 16 Nylock Bolt [5] located at
the lower right rear part of the Hinge [8] (refer
to the Parts List and exploded assembly
diagram) as necessary to correct the
dimension.
(4) Assembly of the Turn Table:
When assembling the Turn Table [35] and the Base [37],
tighten the M6 x 10 Nylock Bolt [40] so that the Turn Table
turns smoothly without excessive play or vibration.
During assembly, liberally apply grease (HI HON KOYU
BC4 is recommended) at the portions marked A in Fig. 5.
Outer
Circumference
--- 9 ---
Gear Case
3.23 --- 63 mm
Fig. A
Turn Table
A
Table Pin
A
A
Base
M6 x 10 Nylock Bolt
Fig. 5