Axis A20 Owner's Manual page 179

Additional steps to complete for storage:
• Thoroughly wash and clean the boat, inside and out, as instructed in the On-Going Care section
of this Owner's Manual.
• Leave the bow slightly elevated so that any further draining of water from the bilge system will
run out and not accumulate inside the bilge system.
• Remove the drain plug(s) and place them in see-through plastic sacks or containers. Place
them inside the boat so that they will be immediately locatable for recommission.
• Disconnect hoses to heaters and/or showers-wash down tanks. Drain, if necessary.
• Using low-tack tape, tape around the exhaust flap so that vermin cannot chew their way into
and nest inside the exhaust system.
• Apply wax to the entire exterior surface to protect the hull and deck finishes, particularly from
dampness and condensation that may occur.
• Disconnect the heater hoses (where equipped) and blow out all water using compressed air.
• Remove the propeller and store in a safe place.
• Remove the seat cushions and store in cool, dry location. Open all storage compartments and
areas to allow air circulation. (Without it, mold and mildew may invade the compartments.)
• Prop the engine compartment lid open several inches to allow for air circulation.
• If the boat will be outdoors, use an optional Axis canvas cover that has been sewn to fit the
boat deck snugly and not allow intrusions of rain and/or snow.
• Chock the trailer wheels if the boat is stored on a trailer.
When recommissioning the boat for the following boating season, reverse the above steps,
plus add the following:
• Check all fluids, oil and coolant. Add, replace or change as necessary.
• Check the engine for cracks and leaks that may have been caused by freezing temperatures
and/or water.
• Check all hose clamps to be certain they are secure and that the rubber hoses have not
deteriorated over the period.
• Reinstall the propeller if it was removed. Grease the shaft taper prior to reinstalling the
propeller.
• Have the alignment between the output flange on the transmission and the propeller shaft
flange checked. An authorized Axis dealer has the measurement detail for correct alignment.
• Prior to starting the engine in the water, key it ON and OFF two or three times, allowing several
seconds between key-on cycles, prior to cranking the engine to fully start. The purpose of this
is to prime the fuel system. If the engine appears reluctant to start, allow a couple minutes of
cool-down for each attempt to crank and start the engine. Watch the gauges/video screen for
readings and listen for abnormal sounds. Keep speeds low until the engine temperature rises
to the normal operating temperature.
Failure to properly perform annual maintenance, plus storage/
winterization procedures as described in this Owner's Manual is likely to
result in damage to the boat, components, drive train and features. Such
damage is not covered under warranty!
Axis
Owners
Manual
2019
Page 168