Flush The Equipment (Solvent-Based Materials) - Graco STX 17Y910 Operation, Parts

Flush the Equipment
(Solvent-Based Materials)
To avoid fire and explosion, always ground equipment
and waste container. To avoid static sparking and
injury from splashing, always flush at the lowest
possible pressure.
• Flush before changing materials, before fluid can
dry or cure in the equipment, at the end of the day,
before storing, and before repairing equipment.
• Flush with a fluid that is compatible with the fluid
being dispensed and the equipment wetted parts.
• Flush at the lowest pressure possible. Check con-
nectors for leaks and tighten as necessary.
• Do not leave the gun or any parts in water or clean-
ing solvents.
1. Follow Pressure Relief Procedure, page 4.
2. Remove nozzle or disk by loosening retaining ring
(3).
3. Remove air control valve (12) and clean all residue
from air passages.
4. Hold a metal part of the gun firmly to a grounded
metal pail. Trigger the gun until clean solvent
dispenses.
5. Store in a dry location.
3A6746B
Pressure Relief Procedure
5