Main Tower Assy; Replacing Fluorescent Lamp And Reflector Lamp; Removing The Game Pcb - NAMCO ACE DRIVER DELUXE Operator's Manual

6-3. Main tower Assy.

6-3-1.

Replacing Fluorescent Lamp and Reflector Lamp

1) Remove the four security screws (M5x12) and the acrylic support bar, then
remove the acrylic board.
2) Replace the fluorescent lamp (12").
3) Unscrew the reflector lamp ( 240v 25w E14 only) to the left to remove.
Refit by screwing the lamp to the right. ( Warning: Make sure the lamp is not
hot before touching it.)
6-3-2.

Removing the Game PCB

1) Remove the rear cover (L).
2) Disconnect the two connectors on the EMI board. Remove the six pozi
head screws (M4x10) to remove the shield case door and earth terminal,
being very careful of the connector that connects the EMI board and Game
PCB, then remove the Game PCB.
Note: Be careful not to lose the internal washer (M4).
Page 24