Adjustments When Replacing Parts (Initialization) - NAMCO ACE DRIVER DELUXE Operator's Manual

5-5 Adjustments When Replacing Parts (Initialization)

The following adjustments should always be performed after replacing the game PC
board, ROM, Steering Assy, Pedal Assy, or Control Pots.
The game will not operate correctly if these adjustments are not made.
a) Ensure that accelerator and brake pedals are fully returned.
b) Place the steering wheel to it's centre position and remove hands from the
wheel
( The steering wheel does not return to centre by itself.)
c) Slide the test switch "ON" while pressing the service switch. The following
screen will be displayed on the monitor.
d) Press the service switch to reset all values to 0000
e) Fully depress and release the accelerator, then the brake, then turn the steering
wheel fully left and right.
f) Slide the test switch "OFF" to return to normal game mode.
*
If the above initialization does not perform correctly, repeat two or three times.
ADJUST MODE
BASE BIAS
STEER: ****
GAS: ****
BRAKE: ****
ADJUST WHILE PRESSING
SERVICE SWITCH.
TO EXIT, TURN OFF TEST SWITCH.
Page 21
VALUE
**** 0000
**** 0000
**** 0000