Hitachi HSC-2100 Hardware Manual page 132

④ Following the specified model number, specify the registration number for the analog
module. To accomplish this, enter a numeric value of 20 directly into the "Address" box,
which is actually the address of slot 0 determined by the STNO setting, and then click the
[OK] button.
⑤ Repeat Steps ① through ⑤ for each of slots 1 through 3.
When all of the analog and counter modules are registered, the window as shown below
appear. Click the [Close] button in the window to exit the module registration session.
5 MAKING USE OF MODULES
5-31
Enter a 20 and click [OK].
Click [Close] to exit the
registration session.