Sears Elite 665.12762K310 Manual page 55

Service Error Codes #5
FUNCTION PROBLEM
CODE CODE
9-DIVERTER 3-DIVERTER
DISC
MISSING
4-LOWER
SPRAY ARM
ERROR
10-OTHER 1-DISPENSER
ELECTRICAL
PROBLEM
2-VENT
WAX
MOTOR
ELECTRICAL
PROBLEM
(NOT ALL
MODELS)
3-DRYING
FAN
ERROR
(ON MODELS
WITH FAN)
For Service Technician Use Only
CAUSES
CONTROL DETECTED DIVERTER DISK IN SUMP IS
MISSING.
MECHANICAL BINDING OR BLOCKING OF SPRAY
ARM.
CORRODED OR LOOSE CONNECTION IN SPRAY
ARM SENSOR/MOTOR CIRCUIT.
OPEN FUSE ON CONTROL TO SPRAY ARM
MOTOR.
FAULTY SPRAY ARM DRIVE CIRCUIT ON THE
CONTROL.
LOOSE CONNECTION IN DISPENSER CIRCUIT
AND/OR OPEN DISPENSER SOLENOID.
OPEN FUSE ON CONTROL TO DISPENSER.
FAULTY DISPENSER DRIVE CIRCUIT ON THE
CONTROL.
LOOSE CONNECTION IN VENT CIRCUIT AND/OR
OPEN VENT WAX MOTOR.
OPEN FUSE ON CONTROL TO VENT.
FAULTY VENT DRIVE CIRCUIT ON THE CONTROL.
LOOSE CONNECTION IN FAN CIRCUIT AND/OR
OPEN FAN MOTOR.
FAULTY FAN DRIVE CIRCUIT ON THE CONTROL.
Kenmore Elite 2013 Stainless Steel Tall Tub Dishwasher
DIAGNOSTICS & TROUBLESHOOTING
WHAT TO CHECK
REMOVE LOWER SPRAY ARM, TURBO ZONE ASSEMBLY, REAR FEED
TUBE AND OUTLET COVER AND VERIFY THE ROUND DIVERTER DISK
IS INSTALLED.
1. CHECK FOR AND REMOVE ANY BLOCKAGE OF LOWER SPRAY ARM
(UTENSILS, POT HANDLES).
2. RUN THE SERVICE DIAGNOSTIC CYCLE AND CHECK FOR THE LSA
OPERATION/FAULT DETECTION (NOTE 10). IF FAILURE STILL
EXISTS THEN:
3. DISCONNECT POWER FROM THE UNIT AND CHECK WIRING
CONNECTION OR DAMAGE AT CONTROLLED LOWER SPRAY ARM
MOTOR AND SENSOR.
4. CHECK "TRIAC FUSE DIAGNOSTIC" NEAR "METER CHECK OF
LOADS" ON PAGE 1 (REPLACE CONTROL IF OPEN).
5. CHECK FOR OPEN OR SHORTED LSA MOTOR WINDING
RESISTANCE. (REPLACE DIVERTER MODULE).
UNPLUG DISHWASHER OR DISCONNECT POWER AND CHECK
RESISTANCES OF DISPENSER SOLENOID OR WAX MOTOR AND ALL
CONNECTIONS IN THE DISPENSER CIRCUIT. FIX / REPLACE OPEN
CONNECTION / PART.
REFER TO FUSE SERVICE & DIAGNOSTIC CHECKS ON PAGE 1 (NEXT
TO METER CHECK DIAGRAM).
UNPLUG DISHWASHER OR DISCONNECT POWER AND REPLACE
CONTROL.
UNPLUG DISHWASHER OR DISCONNECT POWER AND CHECK
RESISTANCES OF VENT WAX MOTOR AND ALL CONNECTIONS IN THE
VENT CIRCUIT. FIT / REPLACE OPEN CONNECTION / PARTS.
REFER TO FUSE SERVICE & DIAGNOSTIC CHECKS ON PAGE 1 (NEXT
TO METER CHECK DIAGRAM).
UNPLUG DISHWASHER OR DISCONNECT POWER AND REPLACE
CONTROL.
UNPLUG DISHWASHER OR DISCONNECT POWER AND CHECK
RESISTANCES OF FAN MOTOR AND ALL CONNECTIONS IN THE FAN
CIRCUIT. FIX / REPLACE OPEN CONNECTIONS OR FAN.
UNPLUG DISHWASHER OR DISCONNECT POWER AND REPLACE
CONTROL.
4-11
n