Removing Diverter Assembly - Sears Elite 665.12762K310 Manual

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To remove the Diverter Assembly:
1. Unplug dishwasher or disconnect power.
2. If not done already, disconnect the diverter motor and
sensor harnesses; and if available, the lower wash arm
motor harness*. (See figure 1.)
*Note: The lower spray arm motor, which is incorporated
into the diverter assembly (see figure 1), is available on
models that have the controlled lower spray arm.
Figure 1 - Diverter assembly w/spray arm motor
3-24 Kenmore Elite 2013 Stainless Steel Tall Tub Dishwasher
n

Removing Diverter Assembly

3. Remove 2 Torx screws, see figure 2. (Diverter assembly
shown without lower wash arm motor.)
Figure 2 - Diverter assembly w/o spray arm motor
4. Lift out, see figure 2.
Note: The diverter disc is keyed onto the motor shaft. The
diverter motor can be removed with out removing the diverter
disc first but to install the diverter motor, the diverter housing
must be removed to align the diverter disc to the motor shaft.
Remove 2 #10 Torx screws
Figure 3