Husqvarna R 322TX AWD Operator's Manual page 29

1. Open the plastic cap on the end of the oil drain plug.
2. To make it easier to drain the oil without spill, attach
for example a plastic hose to the end of the oil drain
plug.
3. Put a container below the oil drain plug.
4. Remove the dipstick.
5. Turn the oil drain plug counterclockwise and pull out
to open it.
6. Let the oil run out into the container.
7. Push the oil drain plug in and turn it clockwise to
close it.
8. Remove the plastic hose and put the cap on the oil
drain plug back.
9. Turn the oil filter counterclockwise to remove it.
10. Lightly lubricate the rubber seal on the new oil filter
with new oil.
11. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
849 - 004 - 21.10.2019
12. Fill with new oil as given in
engine oil level on page 28 .
13. Start the engine and let it idle for 3 minutes.
14. Stop the engine and make sure that the oil filter does
not leak.
15. Fill with oil to compensate for the oil held in the new
oil filter.
Note: For safe disposal of used engine oil, see
on page 34 .
To do a check of the transmission oil
level
1. Remove the two screws, one on each side, and lift
off the transmission cover.
2. Make sure that the oil level in the transmission oil
tank is between the two horizontal lines on the tank.
3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line.
Technical data on page 35 for
Note: Refer to
recommended oil .
To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
To do a check of the
Disposal
29