Husqvarna R 322TX AWD Operator's Manual page 28

To remove and attach the BioClip plug on
cutting deck Combi 103 and 112
1. Put the cutting deck in servicing position.
2. Remove the 3 screws that hold the BioClip plug and
remove the plug.
3. Attach 3 M8x15 mm screws in the screw holes for
the BioClip plug to prevent damage to the threads.
4. Put the cutting deck back in mow position.
5. Attach the BioClip plug in the opposite sequence.
To examine the blades
CAUTION: Damaged or incorrectly balanced
blades can cause damage to the product.
Replace damaged blades. Let an approved
service agent help you sharpen and balance
blunt blades.
1. Put the cutting deck in servicing position.
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
28
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Technical data on page 35 for the types
Note: See
of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To change the engine oil and the oil
filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for
more than 1–2 minutes before you drain the
engine oil. The engine oil becomes very hot
and can cause burn injuries. Let the engine
become cool before you drain the engine oil.
WARNING: If you spill engine oil on your
body, clean with soap and water.
849 - 004 - 21.10.2019