Parts And Operating Controls; Before Using For The First Time; Boiling Water - Siemens 300 Series Instruction Manual

en
Congratulations on purchasing this
Siemens appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid with lock
3 O / I ON/OFF switch, illuminated
4 Limescale filter (removable)
5 Base
6 Cable tidy
Important: Use the kettle 1 only with its
included base 5.
■ Only fill the kettle with water. Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
1 without water and do not overfill it;
observe the min and max markings. If
the kettle is too full, the water will boil
over!
Before using
for the first time
■ Remove any stickers or film.
■ Unroll the right amount of cable from the
cable tidy 6 and plug it in.
■ Fill the kettle 1 with water. Bring the water
to a boil and discard it. Repeat the proce­
dure. This will make sure that the kettle is
clean for normal use.
■ When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
8

Boiling water

■ Remove the lid 2 and fill the kettle 1 with
fresh water through the opening or spout.
■ Read the quantity on the water level indi­
cator. Do not fill with less than 0.25 litres
or more than 1,7 litres of water!
■ Put on the lid 2 at the
to to lock it in place.
■ Press down the O / I ON/OFF switch 3;
the switch lights up. The water is heated.
■ The kettle switches off automatically once
the water has boiled.
The appliance can also be switched off at
any time by pulling up the O / I ON/OFF
switch 3.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
N.B.: Only operate the kettle with the lid 2
closed and the limescale filter 4 inserted,
otherwise the kettle will not switch off.
For physical reasons, the base 5 may
collect some condensation water. This is
normal; it does not mean that the kettle 1
leaks.
After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1
is empty, otherwise the overheat control will
engage and the appliance will switch itself
off automatically.
mark and twist