Bolt The Extruder Back Onto The Extruder Carriage; Push The Active Cooling Duct Back Into Place; Zip-Tie The Wrapped Extruder Cable To The Extruder - MakerBot Replicator 2 Replacement Instructions
Thermocouple
Hide thumbs
Also See for Replicator 2:
- User manual (64 pages) ,
- Quick start manual (14 pages) ,
- User manual (60 pages)
Table of Contents
Advertisement
15. Bolt the extruder back onto the extruder carriage.
16. Push the active cooling duct back into place.
17. Zip-tie the wrapped extruder cable to the extruder.
Position the zip tie as close as possible to the extruder cap and tie it as tightly as you
can.
18. Return the electronics cover to the bottom of your MakerBot Replicator 2.
The thermocouple replacement is now complete. Plug in your MakerBot Replicator 2,
reload your filament and go back to printing.
Advertisement
Table of Contents
Need help?
Do you have a question about the Replicator 2 and is the answer not in the manual?
Questions and answers