EALED SURFACE BURNERS AND COOKTOP
To clean the burners:
Pull the burner cap straight up from the
Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a
non-abrasive scrubbing pad or mild abrasive
Do not clean the burner cap in a dishwasher.
If the gas tube opening has become soiled or
clogged, use a damp cloth to clean the area.
If the ports are clogged, clean them with a
EMOVING THE OVEN DOOR
For normal use of your range, you do not need to
remove the door. However, if you find it necessary
to remove the door, follow the instructions in this
NOTE: The oven door is heavy.
Before removing the door:
Use a putty knife or screwdriver and insert it at
the bottom corner of the door stop clip.
Pry door stop clip free and remove from front
frame hinge slot. Take care not to scratch
Repeat procedure for other door stop clip.
straight pin. Do not
enlarge or distort the
port. Do not use a
If the burner needs to
be adjusted, call a
After cleaning the gas tube opening and ports,
Gas tube opening
Turn on the burner to see if it will light. If the
burner does not light after you have cleaned it,
recheck cap alignment or contact a designated
service technician. Do not service the sealed
Door stop clip
CARING FOR YOUR RANGE
replace the burner
cap. To replace the
burner cap, make
sure the alignment
pins on the cap are
properly aligned with
the burner base.