28
model no. 274-1754-8 | contact us: 1.866.523.5218
CHAIN OILER
• Use bar and chain lubricant. It is designed for chains and chain oilers and
is formulated to perform over a wide temperature range with no dilution
required.
• Remove the cap and carefully pour approximately 2 oz (57 g) of bar and
chain lubricant into the reservoir.
• Replace the cap and tighten securely.
• Check and refill the bar and chain lubricant reservoir every time the pole
saw is used.
WARNING: To avoid possible serious injury, stop the motor and
!
remove the battery from the pole saw before replacing the bar,
chain, or performing any maintenance operation.
!
NOTE: Do not use dirty, used, or otherwise contaminated
lubricants. Damage may occur to the oil pump, bar, or chain.
Remove
Cap
Bar and Chain
Lubricant Reservoir