Replacing The Bar And Chain - Yardworks 274-1754-8 Instruction Manual

26
model no. 274-1754-8 | contact us: 1.866.523.5218

REPLACING THE BAR AND CHAIN

• Loosen the bar cover knob by turning counter-clockwise and remove the bar cover.
• The bar contains a bar stud slot that fits over the bar stud. The bar also contains a
chain tensioning pin hole which fits over the chain tensioning pin.
• Place the bar onto the bar stud so that the chain tensioning pin fits into the chain
tensioning pin hole.
• Fit the chain over the sprocket and into the bar groove. The cutters on the top of the bar
should face toward the bar tip, in the direction of the chain rotation.
Sprocket
Chain
Tensioning
Pin Hole
WARNING: To avoid possible serious injury, stop the motor and
!
remove the battery from the pole saw before replacing the bar,
chain, or performing any maintenance operation.
Sprocket
Bar Cover
Bar Cover
Knob
Chain
Bar
Chain
Tensioning Pin
Bar Stud