Service; Before Calling Service - Bosch GAS RANGE Use And Care Manual

Replacing an Oven Light

Service

Before Calling Service

Troubleshooting Charts
The Cooktop
Table 9: Cooktop Troubleshooting Chart
Cooktop Problem
Cooking results are not what
was expected.
Water takes too long to boil
Burners click continuously
Burners click intermittently
English 28
3. After moving the hinge brackets back down into position, be sure to close and
open the door slowly to assure that it is correctly and securely in place.
4. Door should be straight, not crooked.
Each light assembly consists of a removable lens, a light bulb and a light socket
housing that is fixed in place.
WARNING
• Make sure the appliance and lights are cool and power to the appliance
has been turned off before replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
• The lenses (if equipped) must be in place when using the appliance.
• The lenses (if equipped) serve to protect the light bulb from breaking.
• The lenses (if equipped) are made of glass. Handle carefully to avoid
breaking. Broken glass could cause an injury.
• Light socket is live when door is open
1. Read the WARNING above.
2. Turn off power at the main power supply (fuse or breaker box).
3. Remove the lens by unscrewing it.
4. Remove the light bulb from its socket by unscrewing it.
5. Replace the bulb with a new 40 watt appliance bulb. Avoid touching the bulb
with fingers, as oils from hands can damage the bulb when it becomes hot.
6. Screw the lens back on.
7. Turn power back on at the main power supply (fuse or breaker box).
Use these suggestions before calling for service to avoid service charges
Possible Causes and Suggested Solutions
• The cooktop is not level. Adjust leveling legs on bottom of range.
• Cooking pan is not the appropriate size or type. See "Cookware Selection Guide".
• Time to boil can vary greatly depending on environmental conditions. See "Boiling
Water" on page 16 for tips to decrease time to boil.
• Knob(s) are in the "light" position. Turn knobs to the "OFF" position or to desired
flame setting.
• Moisture has accumulated insdie the ignitor. Turn both front burners to the highest
setting for 15-20 minutes then turn to OFF.