Energetics ST 880 Manual page 10

FUNCTIONS:
TIME
Exercise time will be show on the display when exercising. If there is no signal is detected within 4seconds,it
will halt.
Count up: Without setting the time value, the monitor will count up the time from 0:00 to 99:59.
Count down: setting the exercise time, the monitor will count down from your setting values. Once reach
setting value and monitor will produce bi sounds, and then the value of time becomes counting up form 0:00
COUNT
Count will be shown on the display when exercising. If there is no signal is detected within 4 seconds, it will
reset zero.
Count up: Without setting the count value, the monitor will count up the count from 0 to 9999.
Count down: setting the exercise time, the monitor will count down from your setting values. Once reach
setting value, monitor will produce bi sounds, and then the value of count becomes counting up from 0.
CALORIE
The calories burned will be displayed on the window. Its scope is 0.0-999kcal.
Count up: Without setting the calorie value, the monitor will count up the count from 0.0 to 999.
Count down: setting the calorie consumption, the monitor will count down from your setting values. Once
reach setting value, monitor will produce bi sounds, and then the value of count becomes counting up
form0.0.
DISTANCE
The distance will display will be displayed on the window. The monitor begins to calculate from 1 meter to
999meter and the measure unit is 1 meter. After reach 1 KM, the measure unit become to 0.1KM(100 meter).
The monitor will display from 1.1KM to99.9KM.
Count up: Without setting the distance value, the monitor will count up from 0.1-99.9KM or Mile.
Count down: Setting the exercise distance, the monitor will count down from your setting values. Once reach
setting value, monitor will produce bi sounds, and then the value of count becomes counting up form 1 meter.
PULSE
The monitor will display your current heart beat rate in beats per minute .The value of pulse make count is 40-
220.If signal is input, the monitor will count the beats. If no pulse input is detected within 16 seconds, the
display will indicate "p". This is power saving device.
Setting the pulse value, the heart rate will limit on certain value (90-220) as your setting .One your heart rate
is more than your setting value. The window will blink and remind you the value is higher than your setting
value .You need to work slowly to reduce heart rate.
10