Exit Adjust Mode - Cervis SmaRT CB-xH Manual

SmaRT Console Box Remote
•
To set the maximum value at one increment above the minimum value, flip the
Associate switch (S13) DOWN to store that value.
•
To adjust the current value, slowly move the lever or joystick again until machine
movement is to the desired maximum point. Continue to hold in position and flip the
Associate switch (S13) DOWN to store the value, then release the lever or joystick to
neutral.

Note:
To cancel adjustment of the lever or joystick and return to Select Mode (Max),
allow the lever or joystick to return to neutral – LED 2 on the base unit will light solid.
2. LED 3 will go out and LED 2 will light solid after storing, indicating a return to Select
Mode (Min). Return to Section 2.8.5 to set minimum lever activation.

Note:
Activating the Associate (S13) DOWN and the Adjust switch (S14) UP will toggle
between MIN and MAX while in Adjust Mode.

2.8.7 Exit Adjust Mode

Exit Adjustment Mode by either:
•
Releasing switch and waiting approximately ten seconds for the handheld (when in Select
Mode only) to timeout
•
Pressing the console box Stop switch
•
Pressing the console box ON/OFF switch (S12) DOWN for three seconds, which powers
down the console box.
©2020 Cervis, Inc.
15