Parts List - Brocade Communications Systems DCX-4S Backbone Installation Procedure

1. Unpack the Brocade DCX-4S.
a. Cut the bands that encircle the packaging.
b. Remove the lid and the kits and foam from the top of the chassis.
c. Lift the cardboard box off the chassis and remove the plastic bag from around the chassis.
Save the packing materials for use when returning the old chassis.
d. Leave the chassis on top of the plastic shipping tray if the chassis must be transported to the installation
location.
2. Use a pallet jack or other assisted lift to transport the new chassis to the installation area. Doorways must be
wider than 36 in. (91 cm) to accommodate the chassis on the pallet.
3. Remove the Port-Side Exhaust kit, accessory kit, packing foam, and antistatic plastic from the chassis and set
aside.
Installing with 27 to 31 in. (68.58 to 78.74 cm) kit
Use the following procedures to install the DCX-4S Backbone in a cabinet with rail-to-rail depth of 27 to 31 in.(68.58
to 78.74 cm). Be sure to use the 27-31 in. Port-Side Exhaust Kit for this installation.

Parts list

The following parts list refers to items illustrated in
TABLE 1 Hardware for Port-Side Exhaust Kit for 27 to 31 in. (68.58 to 78.74 cm) cabinets
Item Description
A Top rail
B Duct
C Shelf
D 10-32 x .5 in. (1.27 cm) Phillips screw (blue Loctite on threads)
E 10-32 x .63 in.(1.60 cm) Phillips screw with square cone washer
F 10-32 clip nut for cabinets that have rails with round holes
G 10-32 retainer nut for cabinets that have rails with square holes
H Alignment washer for cabinets that have rails with square holes
I 6-32 x .25 in. (.635 cm) Phillips screw
Port Exhaust Kit Installation Procedure
Publication Number: 53-1001181-04
Figure 1 on page 6.
Quantity
1
1
1
12
12
8
8
12
2
5 of 20