Brocade Communications Systems DCX-4S Backbone Installation Procedure page 15

3. Install the shelf saddle (E in
saddle in the same vertical location as where the shelf installs on the port side of the rack. In using
retainer nut locations on cabinet rails"
side, install the saddle in location 23 on the nonport side. Ensure that the words "THIS SIDE UP" on the saddle
face towards the port side of the rack (refer to
Secure the saddle to the equipment cabinet using four 10-32 screws with washers (G in
two screws on each side of the saddle. Tighten screws according to specifications under
on page 14.
FIGURE 9
Installing saddle to equipment cabinet
Port Side
(Exhaust)
NOTE
For rails with round holes, use the clip nuts (H in
rails with square holes, use the retainer nuts (I in
4. Place the shelf (D in Figure 7
screws with washers (G in
requirements" on page 14.
Port Exhaust Kit Installation Procedure
Publication Number: 53-1001181-04
Figure 7 on page 13) to the nonport side of the equipment cabinet .Install the
on page 14 as example, if the shelf is installed in location 23 on the port
Figure
Install
screws
Figure 7 on page
Figure 7 on page
on page 13) on the saddle then secure it to the cabinet rails using four 10-32
Figure 1 on page 6). Tighten screws according to specifications under
9).
13) on the rails for securing 10-32 screws. For
13). Also refer to
"Clip and
Figure 7 on page 13),
"Torque requirements"
Install screws
Figure 8 on page 14.
"Torque
15 of 20