Brocade Communications Systems DCX-4S Backbone Installation Procedure page 18

Port side exhaust kit

Hide thumbs Also See for DCX-4S Backbone:

FIGURE 12

Securing top rail in cabinet.

Install DCX-4S in cabinet

1. Ensure that the door is removed from the port side of the DCX-4S. For instructions, refer to the corresponding

DCX-4S Backbone Hardware Reference Manual.

2. Use a lift to raise the chassis to the correct level.

CAUTION

Use safe lifting practices when moving the product. (C015)

3. If applicable, lock the wheels of the lift.

4. Carefully lift the DCX-4S and slide it into the cabinet.

5. Secure the DCX-4S to the cabinet with six 10-32 screws with washers, three screws on each side

page 19). Tighten screws according to specifications under

NOTE

Screws, clip nuts, and retainer nuts for securing the DCX-4S to the equipment rack are included in the DCX-4S

hardware accessory kit.

18 of 20

"Torque requirements"

on page 14.

Port Exhaust Kit Installation Procedure

Publication Number: 53-1001181-04

(Figure 13

Table of Contents