Brocade Communications Systems DCX-4S Backbone Installation Procedure page 10

FIGURE 5
Securing top rail in cabinet.
Install
screws
Install
screws
6. Secure the top-rail assembly to the cabinet with four 10-32 screws, two screws on each end of the top-rail
assembly.
•
For rails with round holes:
Use two 10-32 screws with washers (E in
screws according to specifications under
•
For rails with square holes:
Use the two standard 10-32 screws (D in
washers (H in Figure 1 on page
specifications under
Install DCX-4S in cabinet
1. Ensure that the door is removed from the port side of the DCX-4S. For instructions, refer to the corresponding
Hardware Reference Manual.
2. Use a lift to raise the chassis to the correct level.
CAUTION
Use safe lifting practices when moving the product. (C015)
3. If applicable, lock the wheels of the lift.
4. Carefully lift the DCX-4S and slide it into the cabinet.
5. Secure the DCX-4S to the cabinet with six 10-32 screws with washers. Tighten screws according to
specifications under "Torque requirements"
10 of 20
Install screws
Figure 1 on page
"Torque requirements"
Figure 1 on page
6) on each end of the top rail assembly. Tighten screws according to
"Torque requirements"
on page 7.
6) on each end of the top rail assembly. Tighten
on page 7.
6) with blue Loctite on the threads and alignment
on page 7.
Port Exhaust Kit Installation Procedure
Publication Number: 53-1001181-04