Initiating The Device; Adding The Avius Device To The Ultrapoint Application - ULTRACOM AVIUS Manual

4.3 Initiating the device

Start the host device by pressing its power button (Figure C) A
green LED light on the host device will illuminate for three seconds
to indicate that the device is starting up.
If the host device's battery is low, a red LED light will illuminate
for three seconds instead of the green LED light.
Start up the collar by placing the magnet icon on the host
device (Figure D) near the power icon on the side of the battery
compartment of the collar (Figure E).
Hold the host device against the collar for a few seconds and
the green LED light on the GPS compartment of the collar will
illuminate for three seconds to indicate that the device is
initialising and that a connection has been formed.
The collar and host device will form a device pair at the time of
their first initialisation. Subsequently, the devices will establish a
connection automatically when they start up.
Take the collar outdoors so that it connects to the satellites.
While the collar is searching for satellites, the green LED light
blinks once per second.
ENG
When the collar has located a sufficient number of satellites to
provide an accurate location, the green LED light on the collar will
blink once every three seconds.

4.4 Adding the Avius device to the Ultrapoint application

Open the Ultrapoint-application on the mobile device and select"
Devices" from the main menu. Select "Add..." or "+"-icon (depends
on the operating system of the mobile device). For the device
type select "Avius". On the "Device ID"-field input your Avius
device ID-number. You can find the Avius device ID-number from
the first page of the collars manual in the device type sticker. You
can also find the device ID-number in a sticker under the collar of
the Avius device. Input other necessary info like device name and
password to the program and select "Save".
From the devices list select the Avius-device that you added.
Activate the AviusLINK discovery and give the application
permission to start the Bluetooth on your phone. If the area has
multiple Avius host devices, make sure that you are connecting to
the right Avius host device. You can find the host device ID-
34